Electric pick is a double insulated hand-held electric tool powered by single-phase series excited motor. It has the characteristics of safety, reliability, high efficiency and convenient operation, which is widely used in pipeline laying, mechanical installation, water supply and drainage facilities construction, indoor decoration, port facilities construction and other construction projects. It is suitable for pickaxe or other appropriate accessories, such as chisel, shovel that can crush, chisel, excavate, groove and cut masonry structure and asphalt pavement.
1. Characteristics of Electric Pick
The sliding clamping rod design makes the locking more firm and the loading and unloading of pickaxe rod faster. The auxiliary handle wrapped with soft rubber can effectively reduce vibration and cooperate with the 360 ° rotation function to make the operation more convenient and comfortable. Optimize the mechanical structure design to provide extraordinary impact and durability. High quality motor, instant burst of surging power, higher work efficiency. The unique damping spring plate greatly reduces the rear transmission vibration and reduces the operator’s fatigue. Switch locking function, suitable for long-time operation.
2. Operation of Electric Pick
1) Please wear a hard hat (safety helmet), safety glasses and protective mask. It is also recommended to wear dust masks, ear protectors and padded gloves.
2) Before operation, it must be confirmed that the chisel is fastened at the specified position.
3) In general operation, the tool works by vibration. Therefore, the screws are easy to loosen, resulting in disassembly or accidents. Carefully check whether the screws are fastened before operation.
4) In cold seasons or when the tool is not used for a long time, it should be run without load for a few minutes to heat the tool.
5) Be sure to stand in a strong place. When using tools from a high place, it must be confirmed that there is no one below.
6) Hold the tool tightly with both hands.
7) Do not touch tools with your hands.
8) Do not release the tool when rotating. Start the tool only when the tool is picked up by hand.
9) During operation, do not point the chisel to anyone present. The punch may fly out and cause serious personal injury.
10) When the chisel is chiseled into the wall, floor or any place where wires may be buried, never touch any metal part of the tool, and hold the plastic handle or side grip of the tool to prevent electric shock caused by chiseling into the buried wires.
11) Do not touch the chisel or parts close to the chisel immediately after operation. It can burn the skin because it can be very hot.
Post time: Nov-26-2021